1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

6 speed manual problems

Discussion in 'Liberty' started by lenasue44, Oct 28, 2022.

  1. Oct 28, 2022 at 7:00 AM
    #1
    lenasue44

    #1
    lenasue44 [OP] New Member

    Joined:
    Oct 28, 2022
    Member:
    #7050
    Messages:
    1
    Gender:
    Female
    First Name:
    lena
    Vehicle:
    2008 jeep liberty sport 6 speed maual
    I have a 08 Liberty Sport with new clutch kit , dual mass flywheel and slave cylinder . The problem is it goes through the gears easy while its not running but running it dont want too go in any gear (has good clutch pedal) Please help
     
    lenasue44, Oct 28, 2022
    #1
  2. Oct 31, 2022 at 12:33 PM
    #2
    MTgeezer

    #2
    MTgeezer Well-Known Member

    Joined:
    Feb 28, 2022
    Member:
    #6297
    Messages:
    142
    Gender:
    Male
    First Name:
    John
    Vehicle:
    55 CJ 3B
    441 sbc/AGEM22W/"Super"D18/D44s-ARBs-Dutchman
    Assuming the transmission shifted normally before, your new clutch/flywheel/slave cylinder arrangement isn't fully disengaging. It could be all three but I would most suspect the slave cylinder. If it is the same diameter as the old one, it probably still has some air in the system.
     
    MTgeezer, Oct 31, 2022
    #2
    LYFZGOOD and aggrex like this.
Register FREE to Reply!
To Top