1. Welcome to Jeeps.net!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Jeep discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Jeep owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Driveshaft?

Discussion in 'Other Jeep Vehicles' started by 525JoeyYJ, Aug 12, 2017.

  1. Aug 12, 2017 at 12:15 PM
    #1
    525JoeyYJ

    #1
    525JoeyYJ [OP] Well-Known Member

    Joined:
    Dec 27, 2016
    Member:
    #703
    Messages:
    56
    Gender:
    Male
    First Name:
    Joe
    Vehicle:
    1989 Jeep Wrangler YJ
    Hello all! So what do y’all do when you’re converting a short bed 2.5l Comanche to 4X4 and the rear driveshaft can’t be used from a donor vehicle like the tranny and the axle could because the 4.0l sets further back than the 2.5l, so the driveshaft from That is too short?
     
    525JoeyYJ, Aug 12, 2017
    #1
  2. Aug 12, 2017 at 12:16 PM
    #2
    525JoeyYJ

    #2
    525JoeyYJ [OP] Well-Known Member

    Joined:
    Dec 27, 2016
    Member:
    #703
    Messages:
    56
    Gender:
    Male
    First Name:
    Joe
    Vehicle:
    1989 Jeep Wrangler YJ
    The same with the front?
     
    525JoeyYJ, Aug 12, 2017
    #2
  3. Aug 12, 2017 at 7:09 PM
    #3
    aggrex

    #3
    aggrex Well-Known Member

    Joined:
    Sep 12, 2016
    Member:
    #203
    Messages:
    4,913
    DE
    Vehicle:
    Backcountry '16
    Tuffy>AEV>TTO>JW>STech>EVOcage>MagnaFlow>SpiderTrax>RockHard>TF>SpringTail>67design>Bolt>GPCA>Curt>
    Custom length balanced driveshafts are in your future unless you can find some from the 80's.
     
    aggrex, Aug 12, 2017
    #3
    JKBob 25 likes this.
  4. Aug 13, 2017 at 12:44 PM
    #4
    OFFGRID

    #4
    OFFGRID Well-Known Member

    Joined:
    Oct 3, 2016
    Member:
    #317
    Messages:
    2,018
    Gender:
    Male
    First Name:
    Peter
    Houston
    Vehicle:
    1979 Jeep CJ7, 258, TH350, NP208
    Howell fuel injection, header, HEI distributor, TH350, NP208, SOA lift with YJ springs in the front & GW springs in the Rear. AMC20 with G2 1 piece chromos trussed, Dana 30 with G2 chromos and 760x ujoints and MM Stainless Hubs, Geared 4.56. Tom Woods shafts, Metal cloaks, Caged, 37" Toyo MTs.
    OFFGRID, Aug 13, 2017
    #4
    aggrex and JKBob 25 like this.
Register FREE to Reply!
To Top